# What is the compressive strength of CMU?

## What is the compressive strength of CMU?

2000 net psi
Cmu compressive strength is the psi calculated from the net area of the individual unit. The minimum average net compressive strength per ASTM C90, as of the 2014 edition, is 2000 net psi. Previous editions of C90 indicated 1900 net psi.

## What is the average compressive strength of the load bearing concrete hollow blocks?

10.3 MPa
The average minimum compressive strength of a load-bearing concrete hollow block is 10.3 MPa or 1,493 pounds per square inch (psi) according to the National Structural Code of the Philippines [NSCP] of the Association of Structural Engineers of the Philippines (2015).

What is compressive strength of concrete cube?

Concrete compressive strength for general construction varies from 15 MPa (2200 psi) to 30 MPa (4400 psi) and higher in commercial and industrial structures….Compressive Strength of Concrete at Various Ages.

Age Strength percent
7 days 65%
14 days 90%
28 days 99%

What is the maximum compressive strength of concrete?

Concrete compressive strength requirements can vary from 2500 psi (17 MPa) for residential concrete to 4000 psi (28 MPa) and higher in commercial structures. Higher strengths up to and exceeding 10,000 psi (70 MPa) are specified for certain applications.

### What is the maximum compressive strength of non-load bearing CHB?

400 PSI
9. CONCRETE HOLLOW BLOCKS, UNLESS OTHERWISE SPECIFIED SHALL BE 150MM THICK. LOAD BEARING BLOCKS SHALL HAVE A MINIMUM COMPRESSIVE STRENGTH OF 750 PSI (5.175 MPa) WHILE NON-LOAD BEARING SHALL HAVE A MINIMUM COMPRESSIVE STRENGTH OF 400 PSI (2.76 MPa).

### What should be the compressive strength of concrete?

How much does a hollow load bearing concrete block weigh?

The hollow load bearing concrete blocks of the standard size 400 x 200 x 200 mm will weight between 17 and 26 kg (1063 to 1625 kg/m3) when made with normal weight aggregates. Normal weight blocks are made with cement, sand, gravel, crushed stone and air-cooled slag.

How many concrete blocks should be tested for compressive strength?

Similarly, test the remaining 7 blocks and the average of 8 blocks strength is the final compressive strength of concrete masonry unit. Below table represents the value of minimum average compressive strength of individual units.

#### What should the hardness of a concrete block be?

It is desirable that the bearing faces of blocks and plates used for compression testing of concrete masonry have hardness of not less than 60 (HRC).

#### What are the dimensions of concrete masonry blocks?

Concrete masonry blocks are generally made of cement, aggregate and water. Which are usually rectangular and are used in construction of masonry structure. They are available in solid and hollow forms. The nominal dimensions of concrete masonry block vary as follows: Width: 50, 75, 100, 150, 200, 250 or 300mm.