Admin Table of Contents
How much does it cost to fix injector circuit malfunction?
This is going to depend on where the issue is: Faulty injectors – This will cost between $1,000 and $1,500 if you take it to a shop. If you do the work yourself, it will cost you around $800-$1,000 for the injector parts.
What does injector circuit malfunction mean?
Error Code P0200 means the PCM (powertrain control module, also known as ECM or engine control module) has detected a malfunction in the fuel injector circuit. This error code means the sensor’s performance is out of range for either the voltage or the injector circuit’s resistance.
How do I fix P0202 code?
What repairs can fix the P0202 code?
- Fuel injector replacement for cylinder 2.
- Repair or replacement of a faulty wiring harness.
- ECM replacement.
- Fixing connection issues.
How do I fix P0204 code?
What repairs can fix the P0204 code?
- Replacing fuel injector cylinder 3.
- Repairing or replacing the wiring harness.
- Fixing connection issues.
- Replacing the ECM.
What does injector circuit open cylinder mean?
Diagnostic trouble code (DTC) code P0201 stands for “Cylinder 1 Injector Circuit/Open.” It indicates a potential problem with the #1 Fuel Injector Circuit, like a broken wire, loose terminal, burned out injector coil, or some other circuit interruption issue.
What is injector circuit?
The fuel injector circuit controls the fuel injectors and commands how much fuel and when to spray the fuel. This code is set when the ECM detects out-of-range sensor performance for either the voltage or resistance of the injector circuit.
How do you check a fuel injector circuit?
Fuel Injector Resistance Testing
- Turn the multimeter to “Ohms.”
- Place the multimeter leads into the fuel injector plug terminal.
- Read the Ohms, or resistance, produced by the fuel injector.
- Test all the fuel injector Ohm readings.
- Replace the injector if the Ohm value is significantly different than other injectors.
What causes P0202 code?
Error Code P0202 is described as Cylinder 2 Injector Circuit Malfunction. This is set when the PCM (powertrain control module, also known as ECM or engine control module) determined a low or high voltage drop or resistance at the injector, or fault in the wiring of the injector.
What does the code P0202 mean?
Code P0202 indicates an injector misfire on cylinder 2, with the PCM commanding the injector to open but not recognizing a change in electrical current that would indicate the injector fired.
What can cause a P0204 code?
Possible Causes Corroded fuel injector, connections or wiring. Poor or broken electrical connections in the connector or harness. Open or short wiring harness for the cylinder 2 injector circuit. Defective fuel injector power circuits.
What causes fuel injector open circuit?
Here are some of the possible causes of the code: Defective fuel injector. Circuit issues, such as corroded wiring or poor connections. An issue with the PCM, such as software in need of an update.