Table of Contents
Why does my Husqvarna riding lawn mower keep shutting off?
If your Husqvarna mower starts and then shuts off after 5 to 10 minutes or so, the problem is likely fuel related. Husqvarna says this may be due to a clogged fuel filter, restriction in the pick up or an improperly vented fuel cap. A clogged fuel filter restricts the flow of fuel to the tractor’s carburetor.
Why does my Husqvarna mower stall when I engage the blades?
It’s running on bad gas. Stale gas is not as combustible, and it will stop the engine, affecting the function of the blades while they are engaged. Bad gas could also stall the engine when mowing steep areas. This problem is easy to fix, though – just drain out the old gas with fresh gas.
Where is the fuse on a Husqvarna lawn mower?
The fuse holder is located under the battery case cover, in front of the battery, in a small holder.
What kind of engine does Husqvarna yth2148 have?
The engine is a 21 hp briggs model 445777. I adjusted all 4 valves tonight to .004 and it still doesnt run, bogs down when pto is engaged. Again if the choke is pulled out halfway the pto engages better, does not bog down as bad.
Why does my Husqvarna lawn mower stop running?
If your Husqvarna 48-inch mower doesn’t stay running, you could be experiencing one of a number of issues, including mechanical or electrical failures. Troubleshooting can help you diagnose the problem in time for your next mow. If your Husqvarna mower starts and then shuts off after 5 to 10 minutes or so, the problem is likely fuel related.
What to do if your Husqvarna lawn mower dies?
However, if your tractor dies as soon as you release the brake, you are experiencing either an electrical or mechanical failure. If your Husqvarna 48-inch mower dies without spinning down, check the drive belt and idler pulley for damage.
Where to find wiring diagram on Husqvarna lawn mower?
The wiring diagram should be in the back of the parts book and the parts book is a free download from the Husqvarna web site . You will need the numbers off the ID tag to make sure it is the right one.