Admin Table of Contents
How much does it cost to fix the pull cord on a lawn mower?
The cost of a pull cord repair is $19.95 which includes the replacement rope. Additional parts, if needed, will be charged separately.
Can you replace the pull string on a lawn mower?
Remove the Old Starter Rope Some mowers have a shroud covering the top of the mower. After you remove the rewind unit, flip it over and look inside to find the knotted end of the broken rope. Grab it with a pair of needle-nose pliers and pull it out. You’ll thread the new replacement starter rope through this hole.
How do you start a lawn mower without a starter?
Attach a jumper cable from the large lug where the engine starter cable and other lugs connect to the battery cable. Finally, rotate the ignition keys of the lawn mower. If it just clicks without starting the lawn mower, you may need to replace the solenoid.
How do you repair a lawn mower pull cord?
The first step in repairing a pull cord is to remove the rewind assembly from the lawnmower. How you do this will vary depending on your lawnmower model, but it’s usually held on by three or more screws. Some mowers have a shroud covering the top of the mower.
What should I do if my starter rope on my lawn mower breaks?
Replace a broken starter rope on your lawnmower quickly and easily by following this simple step-by-step procedure. You tug one last time to get the lawnmower started, and suddenly the rope breaks and the end goes spinning into the hole. Don’t blow a gasket.
How do you replace a pull string on a push mower?
Replacing a pull string on a push mower is a process that starts by removing the starter assembly from the mower housing. Replace a pull string on a push mower with help from the star of the eReplacementParts.com DIY video repair series in this free video clip.
What do I do if my lawn mower Rewind is loose?
Sometimes, rivets hold the rewind unit to the metal shroud. To access this kind of rewind unit, remove the bolts that hold the shroud to the engine. If the rivets are loose, drill them out and replace them with bolts and locknuts.