Admin Table of Contents
How do you drain the radiator on a 2001 Pontiac Grand Am?
Place the drain pan underneath the lower radiator hose at the radiator and slide the hose off the radiator flange, prying it off with a screwdriver to let the remainder of the coolant drain into the pan.
Where is the radiator on a 2000 Pontiac Grand Am?
ACDelco Radiator They are usually located at the front of the vehicle, behind the grille for maximum airflow.
How do you bleed the coolant on a Pontiac Grand Am?
To bleed the air out, unscrew the 7mm top section while the engine is running until bubbles start coming out. Let it run until it stops bubbling and only coolant comes out, then tighten the 7mm top screw BY HAND(if you use a wrench to tighten it, it will break very easily).
What is the coolant symbol?
2. Coolant Temperature Warning: This warning light indicates that your engine is overheating due to lack of coolant. If this light comes on, pull over immediately and turn off your car. An overheated engine can cause significant damage.
How do you drain the coolant in a Pontiac Grand Am?
Turn the valve 90 degrees counterclockwise using the 1/4-inch ratchet. Allow the fluid to flow out of the radiator. Close the valve by rotating it 90 degrees clockwise with the 1/4-inch ratchet once the flow of fluid stops.
How do you flush the coolant in a Pontiac Grand Am?
Open the radiator cap and coolant reservoir cap. Find the radiator drain by consulting the owner’s manual. Once the container is properly situated, open the drain. Pour in your radiator flush as directed and fill the rest with water to about an inch below the top of the radiator opening.
What kind of antifreeze does a 2002 Pontiac Grand Am take?
Notes: Dex-Cool 50/50, Premixed Do Not add water.
Is it necessary to replace radiator on Pontiac Grand Am?
It’s essential to keep the radiator on your Pontiac Grand Am in good condition, as a leaky radiator can cause overheating and engine damage. Although the process is essentially the same for any year or model, here’s how to replace the radiator in the popular 2001 Grand Am.
Where is the water pump located on a Grand Am?
The water pump housing on the Grand Am V-6 engine is located on the left side of the engine as viewed from the passenger side of the engine compartment. The thermostat housing can be located by following the upper radiator hose to the point it attaches to the engine on the driver side of the engine compartment.
How do you drain a Grand Am radiator?
Disconnect the negative battery cable. Disconnect the lower radiator hose and drain the radiator into a resealable container. Disconnect the fan and the fan shroud, if equipped on your Grand Am. Remove the remaining radiator hoses.
How do you install a new radiator in a car?
Install the new radiator, and tighten the fasteners and clips securely. Reattach the transmission cooler lines, radiator hoses, and the fan and fan shroud. Reconnect the negative battery cable. Fill the radiator with a mixture of half distilled water and half engine coolant.